R2008-15 AUTHORIZING UNDERPASS PAINTING AND SIDEWALK CANOPY AGREEMENT

Home Browse Search

� � � t ; � 5.3.2 Thinning of the paint shall not relieve the Contractor from achieving the specified Dry Film Thiclrness. 6 ENVIRONMENTAL AND SAFETY � 6.1 Air Quality Requirements 6.1.1 Abrasive blasting operations shall be conducted in full compliance with all � current federal primary and secondary air quality standards (40 CFR 50) as well as all state and local air quality requirements. ' 6.1.2 The Contractor shall pursue an"air permit" for the work from the state and local air regulatory authorities. In the event such agency does not require permitting for the work, the Contractor shall obtain this determination from the agency in writing. If the regulatory agency will not furnish written determination, or in the I absence of state and local regulatory authorities, the Contractor shall furnish the Engineer a written discussion of his efforts to obtain an"air permit." 6.1.3 The Contractor shall ensure one hundred (100) percent containment of particulates during abrasive blasting activities. 6.2 Worker Health and Safety 6.2.1 Prior to beginning work, the Contractor must certify that he adopts the Worker Health and Safety Plan included in Section 8 of this Specification. As an alternative, the Contractor may execute his own Worker Health and Safety Plan that adheres to the requirements of 29 CFR 1926.62, "Lead Exposure in ', Construction," provided that the Contractor's plan receives prior review and ', approval by the Railway. Proposed Worker Health and Safety Plans should be !� directed to the Office of Chief Engineer — Bridges and Structures, 99 Spring � Street, S.W.,Box 142,Atlanta, Georgia 30303. �i 6.2.2 The Contractor shall review and discuss the Worker Health and Safety Plan with �I the Engineer prior to beginning work. I 6.2.3 The Contractor shall fully comply with the requirements of 49 CFR 214, "Railroad Workplace Safety." 63 Waste Storage and Disposal 6.3.1 The Contractor shall furnish a sufficient quantity of waste storage drums at no additional cost to the Railway. All drums shall be new or reconditioned, and shall be approved for hazardous waste containment. 6.3.2 All waste is to be analyzed, characterized, and disposed of by the Railway unless specified otherwise. If the Contractor is awarded the task of waste analysis and disposal, the Contractor shall prepare a waste analysis and disposal plan describing the type of analysis to be performed, the laboratory to perform the analysis, the permanent waste disposal facility and waste transport service to be utilized, and measures to secure the waste material prior to its transport from the 6