Laserfiche WebLink
� � �;; <br /> , w � , <br /> inside the coveralls. This procedure shall be .completed while wearing the <br /> respiratory protection. Rolled-up coveralls shall be either stored in plastic bags <br /> for reuse or disposed of in a proper waste receptacle. <br /> 7.16.4 Lastly, respiratory equipment shall be carefully removed and then thoroughly <br /> cleaned, inspected, and properly stored for reuse. Disposable respirators or any <br /> replaced parts from non-disposable respirators shall be disposed of properly. <br /> 7.16.5 Workers will then proceed to the shower room where showers are provided. All <br /> workers who are unable to shower at the work site shall thoroughly wash their <br /> hands, face, and any other exposed skin areas before leaving the work site. All <br /> waste from washing shall be disposed of properly. Workers who are unable to <br /> shower at the work site shall be advised to do so immediately upon arriving at ' <br /> their place of residence. <br /> 7.16.6 If necessary in an emergency situation, workers may exit the contaminated area i <br /> without proper decontamination. � <br /> 7.17 Work Site Cleanup I�i <br /> 7.17.1 The entire work site including the decontamination area shall be cleaned up at <br /> the end of each workday. <br /> 7.17.2 Lead contaminated equipment shall be brought to the decontamination area, <br /> vacuumed using equipment with HEPA filters, and wiped clean. <br /> 7.17.3 Tarps used for containment of lead dust and debris must be carefully swept and <br /> vacuumed using equipment with HEPA filters. <br /> 7.17.4 Workers shall be fully protected during cleanup. All waste generated shall be <br /> disposed of properly. <br /> 7.18 Environmental Protection <br /> 7.18.1 General <br /> a. The Contractor shall perform all necessary packaging and managing of the <br /> industrial wastes generated during the project. <br /> b. The Contractor shall be responsible for the disposal of general trash and <br /> garbage generated during the project. All such material must be taken to a <br /> permitted sanitary landfill. <br /> 7.18.2 Collection and Containerization of Waste Materials <br /> a. The Contractor is to collect, identify, and separate by type all waste material <br /> into one of the following waste streams. Any generated waste type that is <br /> not described below shall be brought to the attention of the Engineer for <br /> specific handling instructions. <br /> i. Spent Abrasive (mineral) — This waste stream shall consist of mineral <br /> fines and paint chips. <br /> 15 <br />