Laserfiche WebLink
a. The end-to-end value as measured with an industry-accepted laser source and <br /> power meter should have an attenuation rating of less than or equal to the <br /> following: <br /> (1) At 1310 nm: (0.35 dB/km x km of cable)+ <br /> (number of connectors x 0.50)+ <br /> (number of splices x 0.10) <br /> (2) At 1550 nm: (0.25 dB/km x km of cable)+ <br /> (number of connectors x 0.50)+ <br /> (number of splices x 0.10) <br /> b. DoIT' loss/attenuation objective for each fiber optic splice is 0.10 dB (with a 0.15 <br /> upper limit) when measured in one direction with an OTDR test set (excluding <br /> connector loss, which is typically 0.50 dB per connector) <br /> 3. Out-of-Spec Testing. Test results outside the specifications listed above shall be noted, but shall <br /> not preclude acceptance of a fiber if the out-of-spec condition does not affect transmission <br /> capability(based on use of then-prevailing telecommunications industry standards applicable to <br /> equipment generally used with the relevant type of fiber) or create a significant possibility of an <br /> outage. <br /> 17 <br />