Laserfiche WebLink
FRONTLINE <br /> COMMUNICATIONS Decatur Police Department <br /> AOWlLon o/./AN Wno6cYWn.I b OSMwd a„o,atln Swims, Crisis Negotiation Vehicle Proposal <br /> • Rated frequency <br /> • Rated amperage <br /> • Continuous rated watts <br /> • Power source P <br /> engine speed <br /> g <br /> Direct drive (PTO)and portable generator installations will comply with Article 445 (Generators) <br /> of the NEC. <br /> Overcurrent protection <br /> The conductors used in the power supply assembly between the output terminals of the power <br /> source and the main over current protection device will not exceed 144.00" (3658 mm) in length. <br /> For fixed power supplies,all conductors in the power supply assembly will be type THHW,THW, <br /> or use stranded conductors enclosed in nonmetallic liquid tight flexible conduit rated for a <br /> minimum of 194 degree Fahrenheit(90 degrees Celsius). <br /> For portable power supplies,conductors located between the power source and the line side of the <br /> main overcurrent protection device will be type SO or type SEO with suffix WA flexible cord <br /> rated for 600-volts at 194 degrees Fahrenheit(90 degrees Celsius). <br /> Wiring Methods <br /> Fixed wiring systems will be limited to the following: <br /> • Metallic or nonmetallic liquid tight flexible conduit rated at not less than 194 degrees <br /> Fahrenheit(90 degrees Celsius) <br /> • or <br /> • Type SO or Type SEO cord with a WA suffix,rated at 600 volts at not less than 194 degrees <br /> Fahrenheit(90 degrees Celsius) <br /> Electrical cord or conduit will not be attached to chassis suspension components, water or fuel <br /> lines, air or air brake lines, fire pump piping, hydraulic lines, exhaust system components, or low <br /> voltage wiring. In addition the wiring will be run as follows. <br /> • Separated by a minimum of 12.00" (305 mm),or properly shielded, from exhaust piping <br /> • Separated from fuel lines by a minimum of 6.00" (152 mm)distance <br /> Electrical cord or conduit will be supported within 6.00" (152 mm) of any junction box and at a <br /> minimum of every 24.00" (610 mm) of continuous run. Supports will be made of nonmetallic <br /> materials or corrosion protected metal. All supports will be of a design that does not cut or abrade <br /> the conduit or cable and will be mechanically fastened to the vehicle. <br /> Bid#253 Page 18 Printed: 5/11/2026 <br />