Laserfiche WebLink
• All grease, oil, rope, preservative and other equipment to be provided by <br /> Contractor. <br /> • Successful contractor must provide a copy of the monthly inspection report or <br /> checklist on each elevator for City and Civic Center records. <br /> 1. Check to ensure car interior is adequately illuminated. <br /> 2. Ride the elevator&listen,look&feel for any unusual noises,vibrations or <br /> abnormal operation. <br /> 3. Check stopping accuracy in both directions at an intermediate floor. <br /> 4. Place call on communication device to ensure call is responded to correctly. <br /> 5. Activate alarm device to ensure alarm bell rings. <br /> 6. Check to ensure elevator cannot move when stop button/switch is activated. <br /> 7. Open&close doors to ensure operation is smooth&quiet. <br /> 8. Lubricate all oil&grease components as required. <br /> 9. Press the door open button during the door closing cycle ensuring that the door <br /> opens&closes after reopening time has elapsed. <br /> 10.Test the curtain-of-light,photocell or safety edge protection at two different heights <br /> &ensure that the door re-opens. <br /> 11. Prevent doors from closing by holding the door open button ensuring that the doors <br /> close in slow speed. <br /> 12. Visually examine the pit&pit equipment looking for worn,damaged or loose <br /> equipment&/or hazardous conditions. Clean when necessary. <br /> 13. Inspect/empty the hydraulic pit can. <br /> 14. Check the condition/operation of the oil return pump. <br /> 15. Check to ensure the pit access door is closed&locked. <br /> 16. Check the operation of the car emergency switch. <br /> 17.Inspect&test the normal&final terminal stopping devices. <br /> 18. Check to ensure that the elevator cannot move when the pit stop switch is activated. <br /> 19. Visually examine the car top&hoist looking for worn,damaged or loose <br /> equipment&/or hazardous conditions. Clean when necessary. <br /> 20. Attempt to run the elevator while unit is on inspection in each direction with the <br /> interlock open. <br /> 21.Visually examine the machine room looking for worn,damaged or loose equipment <br /> &/or hazardous conditions.Clean when necessary. <br /> 22.Check to ensure that any temporary jumpers have been removed. <br /> 23.Check all system event logs&reports. <br /> 24. Check to ensure washer under brake center nut is loose&moveable by hand. <br /> 25. Check the level of the hydraulic fluid in the reservoir. <br /> 26. Check the expiration date on the fire extinguisher. <br /> 27. Check to ensure that there are no flammable liquids in the machine room. <br /> 28. Check to ensure that the machine room door is closed&locked. <br /> 29. Check jack packing gland to see that too much oil is not carrying through. <br /> 30. Check jack plunger for signs of leakage or rust. <br /> 31. Check controller contacts for excessive burning. <br /> 32. Clean&lubricate door& gate operator,check key,set screws&contacts. <br /> 33. Lubricate all bi-parting door tracks as required. <br /> 3 <br />