5784 AMENDING ELECTRICAL CODE OF THE CITY OF DECATUR, ILLINOIS

Home Browse Search

'•�" li. t 3 1. For each service with the following capa- cities: up to 100 amperes, $2.00; 101 through 225 amperes, $3.50; 226 through 400 amperes, $5.00; 401 through600 amperes, $7.50; over 600 amperes, $7.50 plus $2.00 for each 200 amperes or part there- of over 600. 2. For all fixtures to be determined by the number thereof: $4.00 �or any number through 20 and 10� each for additional fixtures over 20; 3. For all branch circu its regardless of volt- age to be determined by the number thereof: 60� each for the first 12 circuits and 20� each for ad- ditional circuits over 12; 4. For special equipment : each heating system regardless of voltage, $2.00; for each lighting or power transformer above 1 KVA, $2.00 each; for each sign requiring 500 watts or less, $1.00; for each sign requiring more than 500 watts, $2.50; 5. For each motor, depending on horsepo�er, as follows: 1 horsepower or less, $1.50; 1.1 through 4 horsepower, $2.25; 4.1 through 7 horsepower, $3.00; 7.1 through 10 horsepower, $3.75; over 10 horsepower, $3.75 plus 10� for each additional horsepower or frac- tion thereof. The maximum charge for a single motor shall be $10.00. tn�en two or more motors of less than one horsepower each are installed under the same per- mit, the aggregate horsepower thereof shall be dete r- mined and the fee shall be $1.50 for each even horse- power of such aggregate and $1.50 for any fractional remainder thereof. d. The minimum fee for any permit shall be $5.00. � � � Section 24. When electrical conductors are installed in base- ments or garages, u�ethe r attached or unattached, of residential structures, said donductoxs shall be placed in approved metal con- duit or metal raceways, unless said conductors are to be concealed behind and protected by approved wall or ceiling covering, or the same do not extend more than 3 feet into such basement. All newly installed service entrance conductors, whethe r installed during con- struction of a new structure or installed in an existing structure, shall be placed in approved rigid metal conduit. Except as provided in this section, approved non-metalic sheathed cable may be used in single family residence structures.